LOREX Technology L15LD400 - Manual (Page 43)

43
EXTERNAL DEVICE
PAN/TILT SETUP - SPEED SETUP
1. PAN SPEED - Set the PANing speed (0 low ~ 7
high).
2. TILT SPEED - Set the TILTing speed (0 low ~ 7
high).
3. ZOOM SPEED - Set the speed of ZOOM IN/OUT
(0 low ~ 7 high).
SPOT SETUP
1. SWITCH INTERVAL - Sets the sequence
switching time (01 ~ 99 sec.).
2. ALARM POP UP - When an Alarm is detected, the
corresponding channel (connected to the Alarm
sensor block) pops up onscreen.
3. MOTION POP UP - Sets the MOTION detection
pop-up to ON/OFF.
4. EVENT POP UP DURATION - If ALARM or
MOTION events occur concurrently on several
channels, then Channel 1 has first priority for
onscreen POP UP.
• For example, if an events occurs on Channel 1,
Channel 2 and Channel 4 at the same time,
Channel 1 pops up. If motion stops on channel
1, then channel 2 pops up for the set duration.
If motion occurs on Channel 1 again (within the
duration), Channel 2 continues to display. If
motion on Channel 1 keeps on going even after
the duration, Channel 1 pops up again.