Lexmark 7600 Series - Manual (Page 129)

Resetting to factory settings
Resetting all settings
You can reset your printer to the original settings without using the printer menus.
Note: Resetting to factory default settings will delete all the printer settings you have previously selected.
1 Turn off the printer.
Note: Make sure the printer is not in Power Saver mode. Press and hold for 2 seconds to turn off the printer.
If you have set the Power Saver timeout in the Setup menu, press and hold according to the time you set in
the menu.
2 From the printer control panel, press and hold and , and then press to turn the printer on.
Resetting menu settings
1 From the printer control panel, press .
2 Press the up or down arrow button until Defaults is highlighted, and then press OK.
3 Press the up or down arrow button until Set Defaults is highlighted, and then press OK.
4 Press the up or down arrow button until Use Factory is highlighted, and then press OK.
5 Press OK again.
6 When prompted, press the up or down arrow button to select a language, and then press OK.
7 Press the up or down arrow button to select a country or region, and then press OK.
Initial Setup Complete appears on the display.
Maintaining the printer
129