LevelOne FPS-3003 - Manual (Page 11)

11
addresses. Besides, you can find Ethernet address that is located on
the backside label of the server.
3.2.3 IP Address
Unless you are assigning an IP address using DHCP, you must obtain
an unused IP address from your network administrator.
3.2.4 Methods for Setting the IP Address
You can set the IP address of your FPS-3003 USB MFP server using
one of the following methods, depending on your network operating
environment:
Automatic IP Address Assignment
Manual IP Address Assignment
3.2.5 Host Names and Host Name Rules
The host name of the FPS-3003 USB MFP server is specified by
“FPS-3003”in Factory Parameter. If you put two or more KMFP servers
in your local area network, to avoid using same host names you have
to change the host names by LevelOne MFP Control Center or server’s
web pages. If your host name is longer than 15 characters, FPS-3003
USB MFP server limits the length of host name to 15 characters.
3.2.6 Set the IP Address Using DHCP
Follow the instructions below to get an IP address using DHCP:
1. Edit or create a scope in the DHCP manager of the DHCP
daemon. The entries included in this scope should contain the
following parameters:
range of IP addresses
subnet mask
default router IP address
DNS server IP address
lease duration
2. Activate the scope. The MFP server automatically gets the DHCP
parameters. If you are using DNS, you may include at least one
DNS server IP address in the DHCP scope or manually set DNS
server IP in MFP server’s web pages or LevelOne MFP Control