Lancom Systems 3550 - Manual (Page 20)

LANCOM 3550 Wireless
࡯ Chapter 2: Installation
20
EN
circumstances, you would assign a configuration password during the
basic configuration (see instructions in the following chapter).
ᕢ
Wireless Link Gives information about the Wireless LAN access of the internal wireless net-
work adapter of the base station. The condition of the optional second exter-
nal wireless network card is not indicated on this display.
The wireless link display can assume four different conditions:
Flashing Power-LED but no connection?
There's no need to worry if the Power-LED blinks red and you can no
longer connect to the WAN.This simply indicates that a preset time or
connect-charge limit has been reached.
There are three methods available for unlocking:
࡯ Reset connect charge protection.
࡯
Increase the limit that has been reached.
࡯ Completely deactivate the lock that has been triggered (set limit
to '0').
If a time or connect charge limit has been reached, you will be notified in LANmonitor. To
reset the connect charge protection, select Reset Charge and Time Limits in the context
menu (right mouse click). You can configure the connect charge settings in LANconfig under
Management
̈ Costs (you will only be able to access this configuration if 'Complete con-
figuration display' is selected under Extras ̈ Options…).
You will find the connect charge protection reset in WEBconfig and all parameters under
Expert Configuration
̈
Setup
̈
Charges- module
Signal for reached time
or connect-charge
limit
Power P
ower
off no Wireless LAN adapter found
green Wireless LAN adapter ready for use
green blinking activity in the Wireless LAN (blink frequency indicates
the number of registered stations)
red flashing error in Wireless LAN (e.g. sending error because of bad
connection)