Lancom Systems 3550 - Manual (Page 36)

LANCOM 3550 Wireless
࡯ Chapter 3: Basic configuration
36
EN
ብ In the following 'Security settings' window, specify a password for config-
uration access. Note that the password is case-sensitive and ensure that
it is sufficiently long (at least 6 characters).
You may specify whether the device may only be configured from the local
network or whether remote configuration via the WAN (i.e. a remote net-
work) is also permissible.
 Please note that enabling this will also permit remote configuration
via the Internet. You should always make sure that the configuration
access is suitably protected, e.g. with a password.
ቦ In the next window, select your DSL provider from the list that is displayed.
Confirm your choice with Apply.
If you select 'My provider is not listed here,' you must enter the transfer
protocol used by your DSL provider manually in the next window. Confirm
your choice with Apply.
ቧ
Connect charge protection can limit the cost of DSL connections to a pre-
determined amount if desired. Confirm your choice with Apply.
ቨ
The basic setup wizard reports that all the necessary information has been
provided. You can end the wizard with Go on.
3.5 TCP/IP settings to workstation PCs
The correct addressing of all devices within a LAN is extremely important for
TCP/IP networks. In addition, all computers must know the IP addresses of two
central points in the LAN:
࡯
Default gateway – receives all packets that are not addressed to comput-
ers within the local network.
Entering the password in the web browser
When you are prompted for a user name and password
by your web browser when accessing the device in the
future, enter your personal values to the corresponding
fields. Please note that the password is case-sensitive.
If you are using the common configuration account,
enter the corresponding password only. Leave the user
name field blank.
Entering the configuration password