Lancom Systems 3550 - Manual (Page 31)

LANCOM 3550 Wireless
࡯ Chapter 3: Basic configuration
31
EN
If you run the LANCOM Router via DSL access with a flat-rate tariff, you can
set the maximum connecting-time in minutes.
Any budget can be deactivated by entering the value '0.'
 In basic settings the charge protection is defined to maximum 600
minutes within seven days. Adapt this setting to your personal needs
or deactivate the charge protection if you have arranged a flatrate
with your provider.
3.2 Instructions for LANconfig
ቢ Start up LANconfig by clicking Start ̈ Programs ̈ LANCOM ̈
LANconfig
LANconfig automatically detects the new LANCOM Router in the TCP/IP
network. Then the setup wizard starts that will help you make the basic
settings of the device or will even do all the work for you (provided a suit-
able network environment exists).
 If the setup wizard does not start automatically, start a manual search
for new devices on all ports (if the LANCOM Router is connected via a
serial port) or in the network (Device
̈ Find).
 If you cannot access an unconfigured LANCOM Router, the problem
may be due to the netmask of the LAN: with less than 254 possible
hosts (netmask > '255.255.255.0'), please ensure that the IP address
'x.x.x.254' is located in your own subnet.
If you have chosen automatic TCP/IP configuration, please continue with
Step
ብ
.
ባ
If you would like to configure the TCP/IP settings manually, assign an
available address from a suitable address range to the LANCOM Router.
Confirm your choice with Next.