Lexicon Blu Ray Disc Player BD-30 - Manual (Page 16)

Lexicon
12
Setting the Remote Code
The remote control supports one of three remote codes. The
default is “Code 1”. If you have other Lexicon products placed
close to the BD-30, they may inadvertently respond to the BD-30
remote control. In this case you can select a different remote code
to avoid conflicts.
To select a new remote code, open the battery compartment cover
of the remote control, and then use a ballpoint pen to flip the
switch to one of the positions marked as “1”, “2”, or “3”. Close
the battery compartment cover. Make sure that the BD-30 player
is turned on and the disc tray is ejected. Aim the remote control
at the player. Press and hold the ENTER button for 5 seconds. The
player will start using the new remote code.
Cautions
• Never drop the remote control or expose it to moisture.
• Never expose the infrared remote sensor on the front panel to
direct sunlight or other strong light sources.
• Remote may not operate consistently when batteries become low.
Replace them if operation deteriorates.
• If the remote control will not be used for a long time, please
remove the batteries.
• Use the batteries correctly to avoid possible leakage and corrosion.
Do not leave the batteries exposed to direct sunlight or high-
temperature environment for a long period of time. Do not heat
or expose to flame. Do not mix old and new batteries. Do not use
batteries of different types at the same time. Do not attempt to
recharge the batteries.
• In case battery leakage occurs, do not touch the liquid with bare
hands. Wipe out any liquid inside the battery compartment, and
insert new batteries.
Installation
Remote Code Switch
Battery Compartment