Lexicon Blu Ray Disc Player BD-30 - Manual (Page 67)

BD-30 Blu-ray Disc Player
63
Setup Menu Options
Secondary Audio: Off (or On if you need
secondary audio)
HDMI Audio: Off
SACD Output: PCM or DSD (depending on
your listening preference)
Coaxial Optical Output: (any – not in use)
LPCM Rate Limit: (any – not in use)
Also set Speaker Configuration in the “Audio Processing” menu:
• Set Down Mix to “7.1Ch” or “5.1Ch”.
• Set the speaker size and subwoofer properly according to your
actual audio hardware (see page 63).
• Enable or select the multi-channel analog inputs on your
receiver.
Coaxial or Optical Digital Audio to Receiver
or Processor
If your audio connection is as described in “Method 6” on
page 18 of this guide, and the A/V receiver supports Dolby Digital
and DTS decoding, the following audio format setup options are
recommended:
Secondary Audio: Off (or On if you need
secondary audio)
HDMI Audio: Off
SACD Output: (any – SACD is not available
through the optical/coaxial
output)
Coaxial Optical Output: Bitstream
LPCM Rate Limit: 48k (or higher if supported by
the receiver)
Stereo Analog Audio to Receiver
If you primarily listen to stereo contents or your receiver only offers
stereo audio connections, please use the analog RCA-style cables
to connect the dedicated Stereo Audio Out of the player to your
receiver, as described in “Method 7” on page 19 of this guide. The
following audio format options are recommended:
Secondary Audio: Off (or On if you need
secondary audio)
HDMI Audio: Off
SACD Output: PCM or DSD (depending on
your listening preference)
Coaxial Optical Output: (any – not in use)
LPCM Rate Limit: (any – not in use)
Audio Processing Setup
The “Audio Processing Setup” section of the Setup Menu system
allows you to configure how the player will process audio signals
before sending them to the output.
Speaker Configuration
In the Speaker Configuration menu you can configure speaker
settings such as down-mix mode, number of speakers, their
distance, size and trim level. The Speaker Configuration menu
shows an illustration of the speaker placements to assist you on
properly configuring the speaker parameters.
Upon entering this menu, the cursor is positioned on the front
left speaker. You may use the LEFT/RIGHT ARROW buttons to
Playback Setup
Video Setup
Audio Format Setup
Audio Processing
Device Setup
Network Setup
Exit
Speaker Configuration
Dolby Pro Logic II
Dynamic Range Control
Off
Auto
Setup Menu
Exit
Configure speaker arrangement for the analog audio output