Lexicon Blu Ray Disc Player BD-30 - Manual (Page 26)

Lexicon
22
Installation
Setting Up the Player – Easy Setup Wizard
Access the Easy Setup Wizard
When the player is turned on for the first time, an Easy Setup
Wizard screen will appear. It is a series of guided instructions
designed to configure the basic settings for the player.
To start the Easy Setup Wizard, please follow these steps:
1) Turn on the TV.
2) Turn on the player.
3) Switch the input selection on your TV so that the TV
displays the signal from the player. You should see the
first step of the Easy Setup Wizard.
If the Easy Setup Wizard has previously been completed or
cancelled, it will no longer initiate when you turn on the player.
Instead, you will see the background screen with the Lexicon and
Blu-ray Disc logos. To access Easy Setup Wizard, please press the
SETUP button on the remote control, select Device Setup, then
Reset Factory Default. Select “OK” to confirm loading the factory
default settings. Once the factory default settings are loaded, the
Easy Setup Wizard will appear.
The first step of the Easy Setup Wizard gives you the opportunity
to skip the entire wizard. If you are familiar with setting up audio/
video equipment and would like to customize the player settings
using its Setup Menu, you may use the LEFT/RIGHT ARROW
buttons to select the “Cancel” option, then press the ENTER key
to exit the Easy Setup Wizard. Otherwise, to continue with the Easy
Setup Wizard, select the “OK” option and press the ENTER key.
Choose the Primary Video Output
The player can output video through its HDMI and component
output terminals. (Composite video output is also available but not
recommended.) By setting the “Primary Video Output” option,
the player can optimize video output of the selected terminal. The
choices are “HDMI” and “Component”. If you connect the player
to the TV using an HDMI cable (Method 1 on page 13, Method 2
on page 14, or Method 4 on page 16), please select “HDMI”. If
you connect the player to the TV using component video cables
(Method 3 on page 15), please select “Component”. Please note:
the best performance will be provided over the HDMI connection.
To make your selection, use the UP/DOWN ARROW buttons to
highlight the choice, and then press the ENTER button to go to
the next step.
Easy Setup
The Easy Setup Wizard will help you configure the
basic settings for this player. More detailed settings
can be accessed at the Setup Menu at any time after
finishing or exiting the wizard.
Press OK to initiate the Easy Setup Wizard, press
Cancel to exit this Wizard immediately.
Step: 1/6
Easy Setup
Previous Next
Step: 2/6
Choose the primary video output that you use.
Better performance will be provided over an HDMI
connection. Component
HDMI