Installation, Ln-15, Connection diagram, across the arc model set-up – Lincoln Electric LN-15 WIRE FEEDER SVM166-A User Manual
Page 11
LN-15
INSTALLATION
A-5
A-5
Work
Clamp
Electrode Cable
Electrode Cable
Electrode Cable
Work
Clamp
Work
Clamp
wire feeder
K1870-1
wire feeder
K1870-1
RANGER 8
SAE 400 WITH CV ADAPTER
ENGINE DRIVEN WELDERS
WITH WIRE FEED MODULE
(LOCAL MODE AND CV ADAPTER)
CV250
CV300
CV400
CC POWER SOURCE
Output
Output Terminals
erminals
Always Hot.
Output
Output Terminals
erminals
Always Hot.
Always Hot.
Output
Output Terminals
erminals
Always Hot.
Order K484 Jumper
Order K484 Jumper
Plug Kit.
Electrode Cable
Work
Clamp
semiautomatic
semiautomatic
semiautomatic
semiautomatic
wire feeder
K1870-1
wire feeder
K1870-1
wire feeder
K1870-1
CV655, DC400, DC600,
DC655, V350-PRO,
RANGER 9, RANGER 300 DLX
COMMANDER 300
COMMANDER 500
RANGER 250
RANGER 305G
Output
Output Terminals
erminals
Always Hot.
Always Hot.
Power source contactor
Power source contactor
switch must be in the
switch must be in the
"ON" position or use a
"ON" position or use a
K848 Junper Plug Kit.
CONNECTION DIAGRAM, ACROSS THE ARC MODEL Set-Up
( See Figure A.1)
Typically used for general fabrication, maintenance and repair jobs because it’s easy to set up and operate.
Requires only one cable-less to carry. Contactor standard on Across The Arc Model.
FIGURE A.1
Although a constant voltage (CV) power source is recommended for best results with Innershield® and gas metal
arc (GMAW) open arc welding, satisfactory general purpose welding may be obtained using the LN-15 with a con-
stant current (CC) power source for non-critical commercial quality mild steel welding applications.