Lincoln Electric INVERTEC SVM101-B - Manual (Page 84)

V300-I
TROUBLESHOOTING & REPAIR
NOTE: Proper capacitor polarity must be noted when
attaching the capacitor to the Switch Board assembly.
6. Install the new Capacitor and tighten the two bolts
to a torque of 55 inch-pounds (6 Nm). Hand tight-
en first, then tighten the bolts in increments of 10
inch-pounds, alternating between the two. See
Figure F.27.
7. Tighten the set screw of the clamping ring
8. Perform the Test After Repair of Switch Boards
and/or Capacitors.
F-54 F-54
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
FIGURE F.29 -- COMPLETE SWITCH BOARD ASSEMBLY READY FOR INSTALLATION
CAPACITOR REMOVAL AND REPLACEMENT (cont.)