Linear AKR-1 User Manual

Page 20

Advertising
background image

IMPORTANT !!!

Linear radio controls provide a reliable communications link and fi ll
an important need in portable wireless signaling. However, there are
some limitations which must be observed.

For U.S. installations only: The radios are required to comply
with FCC Rules and Regulations as Part 15 devices. As
such, they have limited transmitter power and therefore
limited range.

• A receiver cannot respond to more than one transmitted

signal at a time and may be blocked by radio signals that
occur on or near their operating frequencies, regardless of
code settings.

• Changes or modifi cations to the device may void FCC

compliance.

• Infrequently used radio links should be tested regularly to

protect against undetected interference or fault.

• A general knowledge of radio and its vagaries should be

gained prior to acting as a wholesale distributor or dealer,
and these facts should be communicated to the ultimate
users.

FCC NOTICE

Changes or modifi cations not expressly described in this manual
or approved by the manufacturer could void the user’s authority to
operate the equipment.

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

Copyright © 2002 Linear Corporation

217350 D

217350 D IMAGE 20

Advertising