Lincoln Electric IM658-A - Manual (Page 48)

E-2 TROUBLESHOOTING E-2
POWER FEED 10 DUAL
Observe all Safety Guidelines detailed throughout this manual
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
Local Lincoln Authorized Field Service Facility for technical troubleshooting assistance before you proceed.
CAUTION
PROBLEMS
(SYMPTOMS)
POSSIBLE CAUSE
RECOMMENDED
COURSE OF ACTION
1. Rough wire feeding or wire not
feeding but drive rolls are turning.
a. Gun cable kinked and/or twisted.
b. Wire jammed in gun and cable.
Check for mechanical restrictions
in feeding path.
c. Check for current position of drive
rolls Relative to split wire guide
groove.
d. Drive rolls may not be seated
properly.
e. Gun cable dirty. - Clean if neces-
sary.
f. Worn drive roll.
g. Electrode rusty and/or dirty.
Cable frayed, or poor solder joint
at work or electrode lug.
h. Worn nozzle or cable liner. -
Replace if necessary.
I. Partially flashed or melted contact
tip. - Replace if necessary.
j. Incorrect drive roll pressure. -
Readjust if necessary.
k. Improper liner, tip or inner/outer
guides. - Replace if necessary.
If all recommended possible areas of
misadjustment have been checked
and the problem persists, Contact
your local Lincoln Authorized
Field Service Facility.