Lifescan Pocket Scan Blood Glucose Monitor System - Manual (Page 56)

■ Do not remove the test strip from
the meter to apply blood.
■ Do not touch or move the test strip
once the count has begun.
If the Beep option is set to , the
meter will beep when the blood is
applied to the test spot. See “Checking
the Amount of Blood on the Test
Strip,” page 51.
Step 3: Accurate
Results in 45
Seconds.
The meter then
counts down from
45 to 0 seconds,
beeps (if the Beep
option is set to
),
and displays your
result. Remove the test strip only after
the result is displayed.
Blood glucose test results are auto-
matically stored in your meter’s
memory with the time and date they
were performed. In addition, you
may wish to enter an event label and
insulin information. For information
on event labeling and insulin recording
features, see “Event Labeling,” page
54, and “Insulin Recording,” page 56.
Special Messages
The meter displays results from 0 to 600
mg/dL. If your blood glucose test result is
60 mg/dL or below, your meter will beep
in a low tone (if the Beep option is set to
) and display a special message:
49
TESTING
(Example)