Lenovo 6528 - Manual (Page 104)

5. Disconnect the cables from the power-supply cage to the system board and all
internal components.
6. Remove the four black screws that secure the power-supply cage to the
chassis; then, slide the cage toward the front of the server to disengage the
retaining clips
1 from the top of the chassis and lift the cage out of the
chassis.
7. If you are instructed to return the power-supply cage, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the hot-swap power supply cage
This procedure applies only to server models that have hot-swap power-supplies.
To install the hot-swap power supply cage, complete the following steps:
1. Place the power-supply cage into the chassis and slide it toward the rear of the
server until the retaining clips 1 engage the top of the chassis.
88 ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide