Lenovo 6528 - Manual (Page 93)

1 Release tabs
2 Hard disk drive fan assembly
3 Slot
2. Route the hard disk drive signal and power cables through the slots on the
edge of the hard disk drive fan assembly. Make sure that the cables will not be
pinched between the hard disk drive assembly and the hard disk drive
backplane when the assembly is installed.
3. Rotate the hard disk drive fan assembly toward the backplane. Align the right
edge of the hard disk drive fan assembly and the right edge of the backplane.
Make sure the release tabs are fully engaged on the drive cage.
4. Rotate the drive cage toward the front of the server until it stops; then, lift and
hold the retaining tab 1 on top of the drive cage while you rotate the drive
cage into the chassis until it locks into place.
Chapter 6. Installing and replacing customer replaceable units 77