Lenovo 6528 - Manual (Page 189)

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See the ″Parts Listing″ section in the Hardware Maintenance Manual to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Remote access attempt failed. Invalid
userid or password received. Userid
is ’%1’ from TELNET client at IP
address %2.
(%1 = user ID; %2 = IP address,
xxx.xxx.xxx.xxx) Error A user has attempted to log
in from a Telnet session by
using an invalid login ID or
password.
1. Make sure that the correct
login ID and password are
being used.
2. Have the system
administrator reset the login
ID or password.
The Chassis Event Log (CEL) on
system %1 cleared by user %2.
(%1 = CIM_ComputerSystem.
ElementName; %2 = user ID) Info A user has cleared the IMM
event log. No action; information only.
IMM reset was initiated by user %1.
(%1 = user ID) Info A user has initiated a reset
of the IMM. No action; information only.
ENET[0] DHCP-HSTN=%1, DN=%2,
IP@=%3, SN=%4, GW@=%5,
DNS1@=%6.
(%1 = CIM_DNSProtocolEndpoint.
Hostname; %2 =
CIM_DNSProtocolEndpoint.
DomainName; %3 =
CIM_IPProtocolEndpoint.
IPv4Address; %4 =
CIM_IPProtocolEndpoint.
SubnetMask; %5 = IP address,
xxx.xxx.xxx.xxx; %6 = IP address,
xxx.xxx.xxx.xxx) Info The DHCP server has
assigned an IMM IP address
and configuration. No action; information only.
ENET[0] IP-Cfg:HstName=%1,
IP@%2, NetMsk=%3, GW@=%4.
(%1 = CIM_DNSProtocolEndpoint.
Hostname; %2 =
CIM_StaticIPSettingData.
IPv4Address; %3 =
CIM_StaticIPSettingData.
SubnetMask; %4 =
CIM_StaticIPSettingData.
DefaultGatewayAddress) Info An IMM IP address and
configuration have been
assigned using client data. No action; information only.
LAN: Ethernet[0] interface is no
longer active. Info The IMM Ethernet interface
has been disabled. No action; information only.
LAN: Ethernet[0] interface is now
active. Info The IMM Ethernet interface
has been enabled. No action; information only.
DHCP setting changed to by user
%1.
(%1 = user ID) Info A user has changed the
DHCP mode. No action; information only.
IMM: Configuration %1 restored from
a configuration file by user %2.
(%1 = CIM_ConfigurationData.
ConfigurationName; %2 = user ID) Info A user has restored the IMM
configuration by importing a
configuration file. No action; information only.
Chapter 8. Troubleshooting 173