Lenovo 6528 - Manual (Page 77)

9. Take the other end of the signal cable that is attached to the drive backplane
section for drive bays 0 through 3 (as labeled on the front of the drive cage)
and connect it to the connector that is closest to the battery on the PCI card.
10. Replace the hard disk drive fan assembly:
a. Insert the hard disk drive fan assembly retaining tab over the right edge of
the hard disk drive backplane; then, rotate the hard disk drive fan assembly
toward the backplane. Do not fully close the hard disk drive fan assembly.
b. Route the signal cables and power cable through the slot on the edge of
the hard disk drive fan assembly. Make sure that the cables will not be
pinched between the hard disk drive fan assembly and the hard disk drive
backplane when the assembly is installed.
c. Rotate the hard disk drive fan assembly toward the backplane until the
release tabs are fully engaged and snap into place.
11. Reconnect the hard disk drive fan assembly cable to the system board.
12. Rotate the drive cage back into the server until it stops; then, press and hold
the retaining tab on top of the drive cage while you rotate the drive cage into
the chassis until it is in the closed position.
13. Reinstall the hard disk drives.
Note: Before you continue, check all internal power cables to make sure that
they are connected to the system board and other optional devices.
14. Replace the side cover (see “Installing the side cover” on page 33). Go to
“Completing the installation” on page 67.
15. Lock the side cover.
16. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing a USB embedded hypervisor flash device
To remove the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 29.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Unlock and remove the side cover (see “Removing the side cover” on page 32).
4. Unlock the USB retaining latch by squeezing the two retaining clips toward each
other. Then, lift up the bracket cover.
5. Grasp the flash device and pull to remove it from the connector.
6. Press down on the retaining latch to return it to the original position.
7. If you are instructed to return the flash device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Installing a USB embedded hypervisor flash device
To install the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 29.
2. Turn off the server and all attached devices; then, disconnect all power cords.
3. Unlock and remove the side cover (see “Removing the side cover” on page
32).
4. Unlock the USB retaining latch by squeezing the two retaining clips toward
each other.
Chapter 5. Installing and replacing optional devices 61