LevelOne FPS-3002USB - Manual (Page 19)

Level One Printer Servers
Figure 12: Print Port Setup (Peer-to-peer Printing)
If your LevelOne Printer Server is not listed:
• Click the "Refresh" button.
• Check that both the LevelOne Printer Server and the printer are properly
connected, and powered on.
• Check that the LevelOne Printer Server has been configured. (Use the Setup
Wizard on the CD-ROM.)
• If using TCP/IP, try installing the NetBEUI protocol. (See the earlier section
Checking your Network Protocols for details.). Then try again.
2. Select the desired port on a LevelOne Printer Server, then click Next. A pop-up message
will inform you if the port has been created successfully.
If you see the following error message, either install Internet
Explorer 4 or later, or follow the procedure in the "Trouble
Shooting - Windows" section of Chapter 8.
3. The printer port will be created, then a screen like the following will be displayed.
- 16 -