LevelOne FPS-3002USB - Manual (Page 39)

6
Chapter 6
Web-Based Management
This chapter explains how to use your Web Browser to configure the
LevelOne Printer Server
Overview
The LevelOne Printer Server incorporates a HTTP server. This allows you to connect to the
LevelOne Printer Server and configure it using your Web Browser. Most browsers should work,
provided they support tables and forms.
Preparation
Because it supports dynamic IP Address allocation using DHCP, BOOTP, or RARP, the
LevelOne Printer Server ships with an IP Address of 0.0.0.0. This is NOT a valid IP Address.
Therefore, you must do ONE of the following:
• Check your DHCP server (if you have one), and determine the IP Address allocated to the
LevelOne Printer Server.
• Use the Setup Wizard, BiAdmin or another LevelOne Printer Server utility to allocate a
valid IP Address to the LevelOne Printer Server.
• Add an entry to the arp table to associate the hardware address of the LevelOne Printer
Server with the desired IP address, as follows:
arp -s IP_Address 00:c0:02:xx:xx:xx (Unix)
arp -s IP_Address 00-c0-02-xx-xx-xx (Windows)
Where:
IP_Address
is the IP Address you wish to assign to the LevelOne Printer Server.
00:c0:02:xx:xx:xx is the hardware address of the LevelOne Printer Server.
Example (Unix):
arp -s 192.168.0.21 00:c0:02:12:34:56
Example (Windows):
arp -s 192.168.0.21 00
−c0−02−12−34−56
Note: The hardware address of the LevelOne Printer Server is shown on a sticker on the base
of the device.
- 36 -