LevelOne FPS-3002USB - Manual (Page 33)

Level One Printer Servers
TCP/IP Tab
Selecting this tab will allow configuration for the TCP/IP network protocol. The basic options
are:
• Dynamic IP Address (DHCP) - The IP address is obtained automatically, from a DHCP
Server on your network.
• Fixed IP Address - You must enter the IP address, Subnet Mask, and Gateway Address.
• IP Address - Select an unused IP address from the address range used on your LAN.
• Subnet Mask - Use the same values as PCs on your LAN (or on the same LAN
segment, if you have a Router).
• Gateway - Use the same values as PCs on your LAN (or on the same LAN segment, if
you have a Router).
Some LevelOne Printer Server models also support the Auto-IP function. If the LevelOne
Printer Server is set to Dynamic IP Address, but there's no DHCP server found on the network,
the LevelOne Printer Server will get an IP from the range of 169.254.1.1 ~ 169.254.254.254
automatically. In this case, even though the LevelOne Printer Server was initialized with an
Auto-IP, it will change to DHCP whenever a DHCP server is detected.
Figure 25: TCP/IP Screen
The TCP session parameters should only be changed if advised to do so by your Network
Administrator or LevelOne Printer Server Technical Support.
- 30 -