Line 6 POD Farm UX1 - Manual (Page 145)

Line 6 POD Farm 1.01 – Troubleshooting
8•4
On Windows ® , the latest PC’s typically utilize the Serial ATA (SATA) interface format for Hard
Disks, which is fast and typically requires no user tweaking. But if your PC utilizes the IDE Hard
Disk controller interface type, check that your internal IDE controller (which controls your hard disk
and CD/DVD drives in your computer) is configured for DMA mode for higher speed operation. To
configure your drives to use DMA mode under Windows ® :
Click on the Start button, and select Settings > Control Panel. •
Double-Click the System icon. •
Select the Hardware tab, and press the Device Manager button. •
Select the IDE ATA/ATAPI Controllers tree and open it. •
Check each IDE channel to make sure the Transfer Mode is set to • DMA if available.
You must reboot your machine if you make changes to these settings. •
p Return to Troubleshooting List
Why can’t I hear the effects?
Are any models bypassed? Each individual effect and amp/preamp can be bypassed independently by
clicking on the bypass button beneath it in the Signal Flow View. A bypassed effect appears dimmed,
with the bypass button lit. Note that amp and preamp models can be individually bypassed this way
as well.
Effect Bypass button Effect in Bypassed state
Is the Tone signal flow Muted? Both Tone 1 and Tone 2 offer a Mute button at the top left of their
Signal Flow. If active, this of course silences the entire Tone independently of the other - the Signal
Path of the tone is dimmed when muted.