Line 6 POD Farm UX1 - Manual (Page 16)

POD Farm 1.01 – Using Your Line 6 Hardware
2•2
GX (POD Studio & TonePort)
Connect your electric
Guitar or Bass
Instrument Input - To input your electric guitar or bass, plug it in here using a standard 1/4-inch TS
instrument cable. When in POD Farm Standalone operation, this inputs the signal into POD Farm,
where you can choose your Tone, and then route the processed signal both to the Record Sends (to
your audio software) and directly to the GX hardware outputs.
Connect your stereo
Headphones/Line Out Cable
Connect USB cable from here
to your computer
USB - This of course is where you connect the supplied USB cable to GX, with the other end going
to your computer’s USB 1.1 or 2.0 port.
Line Out/Phones - Connect here to either a monitoring system or stereo headphones, using an 1/8-
inch stereo cable. When connecting GX as an audio interface for your recording application, this line
out/headphone jack outputs the playback audio from your audio software on the computer, as well as
anything plugged into the Instrument input. If you ‘re using a 3rd-party audio interface, these outputs
supply the ToneDirect™ magic to your interface or mixer, when using POD Farm in Standalone
operation alongside the plug-in. See the ToneDirect™ Monitoring section for more details.