Line 6 POD Farm UX1 - Manual (Page 20)

POD Farm 1.01 – Using Your Line 6 Hardware
2•6
TonePort UX8
TonePort UX8 is a multichannel recording interface designed for professional use, offering plenty
of headroom, a wide dynamic range and an exceedingly low noise floor. Designed with high quality
electrical components and a rugged exterior, UX8 is built to provide many years of reliability.
UX8 can be used with the POD Farm Plug-In, providing all your DAW tracks with same POD quality
Tone trusted by scores of platinum-selling musicians and recording engineers!
Rear Panel Features
Balanced Outputs
UX8 provides 8 balanced analog outputs (4 stereo pairs). For the cleanest audio signal, use 1/4-inch
TRS cables to connect directly to your powered speakers, mixer or power amp setup.
Note that you can use each output pair to provide different monitor mixes for musicians during a
tracking session. You can set the input mix levels for each output pair using the Line 6 Audio-MIDI
Devices application.
S/PDIF Digital Audio
To send or receive S/PDIF, connect a 75-Ohm coaxial cable to the UX8’s RCA jack and the external
S/PDIF device. This is the best choice for connecting to digital recording devices, such as a DAT
recorder, MiniDisc, etc. This S/PDIF output sends the same audio as Main Outs 1-2. The digital signal