Line 6 POD Farm UX1 - Manual (Page 25)

POD Farm 1.01 – Using Your Line 6 Hardware
2•11
any audio coming into the Monitor In jack is not routed to the S/PDIF output). The digital signal is
always sent at 24-bit resolution.
Monitor In - If you want to hear the signal from a line level source mixed with all the other audio
coming from your computer, but do not want this audio recorded via the POD Farm Record Sends,
then plug the source in here. Note that this is a stereo jack, so you should use a stereo 1/4-inch TRS
audio cable for this connection.
Analog Outs - These Left and Right balanced jacks output all the audio from KB37; the audio from
your DAW, and anything plugged into any KB37 input. So, these are what you want to connect to your
monitoring system when using KB37 as your computer’s sound card. Use either 1/4-inch TS or TRS
cables to connect directly to your powered speakers, mixer or power amp setup. Note that you can also
use the headphone jack if you want to use headphones for monitoring.
TonePort DI
Connect your electric Guitar
or Bass
Instrument Input - To connect your electric guitar or bass, plug it into this input. When using POD
Farm in Standalone operation, this connection routes the instrument’s signal into POD Farm where
you can choose your Tone, and then route the processed signal to the Record Sends (to your audio
software) and to the Analog Outs. This input also features a Pad switch; engage this switch when using
a guitar/bass with high-output or active pickups, to avoid overdriving the input.