Line 6 POD Farm UX1 - Manual (Page 80)

Line 6 POD Farm 1.01 - POD Farm Plug-In
4•9
Effects View
Selecting any Effect in the Signal Flow View displays its controls in the Panel View...
Effect Bypass Button Effect Model Menu Pre/Post Toggle Host Sync/Tap Tempo Options
FX Time/FX Speed Controls
Effect Bypass Button - Bypasses the displayed effect without removing it from the signal flow.
Effect Model Menu - Displays the name of the current effect model. Click on the downward arrow
next to the name to select another model from within the current effect model category.
Pre and Post Toggle Buttons - With these buttons you can move the effect’s position within the signal
flow.
Click the Pre button to place the effect before the Amp*. •
Click Post to place the effect after the Amp, and near the end of the signal chain. •
*Note - Placing effects that offer stereo output (many Modulation and Delay effects are stereo
effects, for example) in the Pre position will change their output to mono, so that it can be
routed into the Amp as a single, mono input.
Host Sync and Tap Tempo Options (Master Tempo) - For most Delay and Modulation category
effects, you’ll see these options available at the top right of the Panel View. These allow you to set a
“Master Tempo” that all time-based effects in the Plug-In can automatically follow - this is how you
can get those echo repeats and swirly modulation effects to run “in time” with your song! (Note that
individual effects can alternatively have their tempo set independently - see the following FX Time/FX
Speed controls description). For this Plug-In Master Tempo, there are two “modes” of operation - sync
to the DAW host versus setting a BPM manually:
Host Sync On Host Sync Off
Host Sync - Click the Host Sync button to activate this feature. This sets the POD Farm Plug-In
Master Tempo to follow the current project tempo of the VST/AU/RTAS host software. Note that
even if your host project includes tempo changes, POD Farm Plug-In will follow those changes as
well when Host Sync is active! To have a Modulation or Delay effect utilize this Host Sync Master
Tempo, you additionally need to set the effect’s FX Time/FX Speed - Sync On/Off button to “On”.