Stove installation, Mobile home requirements – Lopi Leyden 028-S-75-2 User Manual

Page 15

Advertising
background image

Stove Installation

(for qualified installers only)

15

© Travis Industries

100-01177

4060802

Mobile Home Requirements

Outside air must be installed - see "Outside Air Requirements" on page 13

Chimney connector and chimney must be one of the following types:

AMERI-TEC model DCC connector with AMERI-TEC UL 103 HT chimney
DURAVENT model DVL connector with DURAVENT UL 103 HT chimney
GSW Super Chimney Twenty-One connected directly to appliance
I.C.C. Excel HP connector with I.C.C. UL 103 HT chimney
METALFAB model DW connector with METALFAB UL 103 HT chimney
OLIVER MACLEOD PROVENT model PV connector with OLIVER MACLEOD UL 103 HT chimney
SECURITY model DP connector with SECURITY UL 103 HT chimney
SELKIRK model DSP connector with SELKIRK UL 103 HT chimney
Standard Masonry Chimney with any one of the above listed connectors

NOTE: Reduced clearance connectors may not connect to the flue collar – an appliance adapter may be required.

Stove placement must maintain the following clearances to combustibles (drywall, furniture, etc.)

A

B

F

C

Measure clearances from the

nearest edge of the stove top.

D

E

C

Figure 11

Minimum Clearance
(See the illustration above)

Reduced Clearance

Connector

A

Sidewall to stove

18.00”

B

Backwall to stove

20.75”

C

Cornerwall to stove

14.00”

D

Connector to sidewall

28.25”

E

Connector to backwall

14.00”

F

Connector to cornerwall

17.50”

If using offsets, use the connector clearance listed in Figure 12,
not the connector manufacturer's clearance.

The appliance must be secured to the floor (consult your
building official). Secure the outside air boot to the floor and
stove to insure the stove does not dislocate.

Mobile home installations require a spark arrester at the
chimney termination.

The appliance must be grounded to the chassis of the mobile
home (consult your building official).

WARNING:DO NOT INSTALL IN SLEEPING ROOM.

CAUTION:THE STRUCTURAL INTEGRITY OF THE MOBILE
HOME FLOOR, WALL, AND CEILING/ROOF MUST BE
MAINTAINED.

12” Min.

Connector Clearance
(as outlined above)

Stove Clearance
(as outlined above)

Figure 12

Advertising