Lopi Leyden 028-S-75-2 - Manual (Page 25)

Operating Your Appliance 25
© Travis Industries 100-01177 4060802
Blower Operation
The blower is available to assist the convection chamber in distributing heat to your home. The directions
below detail the options you have with the blower and the best method for operation.
OFF
Turn the dial all the way counter-
clockwise until it clicks off.
BLOWER
CONTROL
RUN
OFF
START
HIGH
The high position is all the way counter-
clockwise, without clicking off.
BLOWER
CONTROL
LOW
Turn the dial all the
way clockwise.
BLOWER
CONTROL
RUN
OFF
START
RUN
OFF
START
Route the power cord in a location where it will not come in contact with the appliance or become hot.
Re-Loading the Stove
Follow the directions below to minimize smoke spillage while re-loading the stove.
1 Open the air control all the way (pull it out). Open the bypass (rotate it down).
2 Open the loading lid. Let the airflow inside the firebox stabilize before opening the loading lid fully.
3 Load wood onto the fire.
Overnight Burn
This stove is large enough to accommodate burn timesover twelve hours. Follow the steps listed under
“Burn Procedure Pictorial Overview” on page 27
Differences if chimney height and draft may lower overall burn times.
Normal Operating Sounds
Creaks and Clicks:
The steel may creak or click when the stove heats up
and cools down - this is normal.
Blower Sounds:
The optional blower will make a slight "humm"
as it pushes air through the stove.