Lucent Technologies Cajun Switch P220 - Manual (Page 10)

Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1 10
5. Use the CLI
setup
command to configure the switch.
6. Restore the binary configuration files of the release (3.1 or previous) you want to
restore. These configuration files do not reflect any changes you made to the
running configuration while using Release 4.0.1.
Problem: Release 4.0.1 of the Cajun switch contains new range-checking procedures
that may be reasonably more restrictive than those of previous releases.
Workaround: If you have a parameter in 3.1 that is outside the 4.0 range, it will be
noted in the Script Log File. After the second reboot the switch, check the Script Log File
to find out if any errors occurred as the script executed. To check the Script Log File, click
Script Log File in the CLI Configuration section of the Web Agent. If errors were
found, scroll up to find the particular error message. If you prefer to use the Enhanced
CLI, at the system prompt, type:
show file logfile.txt
.
NOTES:
• Some of the associated CLI command incorrectly list “Multilayer” and “3Com”.
These are not supported by the Cajun P550 48-Port 10/100 Media Module (M5548E-
100TC).
• In Release 4.0.1 of the Cajun switch, the Web Agent provides a new set of dialog
boxes in which you can:
- View startup and running configuration files
- View script execution log files
- Copy and manage configuration files
Ensure that you copy configuration files to a TFTP server or other storage location using
the Configuration File Management dialog box.
Upgrading from Release 3.1 or Previous Releases
Use the following procedure to upgrade the switch from Release 3.1 to Release 4.0.1.
NOTE: The Cajun switch does not support a direct upgrade to Release 4.0.1 from
releases prior to Release 3.0. If your switch runs a release prior to 3.0, upgrade the
switch to Release 3.0 or 3.1. Then, use the following procedure to upgrade the switch
from Release 3.0 or 3.1 to Release 4.0.1.