Lucent Technologies Cajun Switch P220 - Manual (Page 29)

Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1 29
N/A clear tcp all Clear all TCP connections that aren't
in the listening state.
Command Mode: Configuration
N/A clear tcp local <ip-
address> <tcp-port>
remote <ip-address>
<tcp-port>
Clear the TCP connection specified by
the local IP address and port and
remote IP address and port.
Command Mode: Configuration
N/A To Enable:
ip bootp-dhcp gateway
To Disable:
[no} ip bootp-dhcp
gateway
Enable or disable the designation of
this interface as the preferred receiver
of BOOTP/DHCP requests received on
a VLAN.
This is useful with multinetted inter-
faces. If no multinetted interface has
this parameter set to Enabled or is not
UP, the router chooses an interface to
receive the BOOTP/DHCP request.
Command Mode: Interface
System Supported: P550R
ip max-arp-entries
<value>
To Enable:
N/A
To Disable:
[no] ip max-arp-entries
The no form of this command restores
the maximum number of ARP cache
entries to the default, which is 16384.
System Supported: P550R
ip max-route-entries
<value>
To Enable:
N/A
To Disable:
[no] ip max-route-
entries
The no form of this command restores
the maximum number of routes to the
default which, is 16384.
System Supported: P550R
To Enable:
ip redirects
To Disable:
[no] ip redirects
N/A The default state is enabled, unless
VRRP is configured.
System Supported: P550R
ip telnet inactivity-
period <timeout>
To Enable:
N/A
To Disable:
[no] ip telnet
inactivity-period
Use the no form of this command to
restore the default, which is 900 sec-
onds, or 15 minutes.
System Supported: P550R
N/A show arp [<ip
addr>][<if-
name>][static]
Display the Address Resolution Proto-
col (ARP) cache.
This command is equivalent to the
show ip arp
command.
• ip-addr – the IP address.
• if-name – the interface name.
• static – displays static arp
information.
Command Mode: User
System Supported: P550R
Table 1-7: IP Commands (Continued)
Old Command New Command New Definition/Argument