Lucent Technologies Cajun Switch P220 - Manual (Page 38)

Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1 38
SNMP Commands
Table 1-14 shows new and changed SNMP Commands in Release 4.0.1:
Switch IP Commands
Table 1-15 shows new and changed Switch IP Commands in Release 4.0.1:
N/A show module counters
[<mod-num>]
Display the aggregate switch port sta-
tistics for a specified module or all
modules on a Cajun P550 or P550R.
• mod-num – Specifies the number
of the module in the chassis for
which aggregate switch port
statistics are to be displayed. (Valid
on Cajun P550 and P550R only)
Command Mode: User
N/A show port
physical[{<mod-
num>|<mod-port-
range>}[...,{<mod-
num>|<mod-port-
range>}]]
Display the physical port configuration
of the specified ports.
• mod-num
• mod-port-range
Command Mode: User
Table 1-14: SNMP Commands
Old Command New Command
New Definition/Argument
N/A To Enable:
snmp-server location
<string>
To Disable:
[no] snmp-server
location <string>
Set the system location string. Use the
no form of this command to remove
the system location string.
<string> – the system location
string.
Table 1-15: Switch IP Commands
Old Command New Command New Definition/Argument
set ip route {default|
<dest-ip-addr> <mask>}
<gateway-ip-addr>
N/A Default: The CLI searches for the
matching interface as indicated by the
gateway IP address and installs the
default gateway on that interface.
Table 1-13: Port Commands (Continued)
Old Command New Command New Definition/Argument