Lucent Technologies Cajun Switch P220 - Manual (Page 27)

Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1 27
DVMRP Commands
Table 1-5 shows new and changed DVMRP Commands in Release 4.0.1:
show buffering
fabric-port
[<fabric-port-spec>
[...,<fabric-port-
spec>]]
N/A <fabric-port-spec> – fabric port specifier - (#/
#, #/FORE, #/#-#/# on P550)
(CPU,G1,G2,G3,G4,G5,G6,G7,A1 on P220G)
(CPU,G1,A1,1-12,13-24 on P220).
show buffering port
[<mod-port-spec>
[…,<mod-port-
spec>]]
show buffering port
[<mod-swport-spec>
[…,<mod-swport-
spec>]
<mod-swport-spec> – switch port specifier -
(#/# on P550/P550R) (A1...A4 on P220G)
(A1...A4, 1...24 on P220).
Table 1-5: DVMRP Commands
Old Command New Command New Definition/Argument
To Enable:
ip dvmrp interface
type {broadcast|
nonEncapsulatedTunnel|
IPIPTunnel}
To Disable:
[no] ip dvmrp
interface type
N/A A tunnel endpoint address must be set
before a DVMRP interface is config-
ured to be a tunnel. Use the [no] ip
dvmrp remote-tunnel-address
<IP-address>
command to set the
tunnel endpoint address.
To Enable:
ip multicast ttl-
threshold <ttl-thresh>
To Disable:
[no] ip multicast ttl-
threshold
To Enable:
ip multicast ttl-
threshold {0,127,255}
To Disable:
no ip multicast ttl-
threshold
{0,127,255} – The TTL (time-to-live)
threshold.
show ip dvmrp
forwarding cache
N/A System Supported: P550R
Table 1-4: Buffering Commands (Continued)
Old Command New Command New Definition/Argument