Lucent Technologies Cajun Switch P220 - Manual (Page 28)

Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1 28
IGMP Commands
Table 1-6 shows new and changed IGMP (Internet Group Management Protocol MIB, draft-ietf-
edmr-igmp-mib-12.txt) commands in Release 4.0.1:
IP Commands
Table 1-7 shows new and changed IP Commands in Release 4.0.1:
Table 1-6: IGMP Commands
Old Command New Command New Definition/Argument
To Enable:
ip igmp process-leaves
To Disable:
[no] ip igmp process-
leaves
To Enable:
ip igmp process-leaves
{0,1}
To Disable:
[no] ip igmp process-
leaves
• 1 – Enables the processing of leave
requests on an interface.
• 0 – Disables the processing of leave
requests on an interface.
Use the no form of this command to
set the command back to the default,
which is 1 enabled.
To Enable:
ip igmp querier
To Disable:
[no] ip igmp querier
To Enable:
ip igmp querier {0,1}
To Disable:
[no] ip igmp querier
• 1 – The interface is a group querier
on the interface.
• 0 – The interface is not a group
querier on the interface.
Use the no form to set the command
back to its default, which is 0 not
group membership querier.
This command is for IGMP release 1
only.
N/A show ip igmp interface Display IGMP multicast-related infor-
mation for all IGMP interfaces.
Command Mode: User
System Supported: P550R
Table 1-7: IP Commands
Old Command New Command New Definition/Argument
To Enable:
arp <ip-address>
<hardware-address>
To Disable:
[no] arp <ip-address>
<hardware-address>
N/A System Supported: P550R
clear ip route
{<network> [<mask>] *}
N/A System Supported: P550R