Lucent Technologies Cajun Switch P220 - Manual (Page 31)

Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1 31
N/A To Enable:
ipx max-service-entries
<max-service-entries>
To Disable:
[no] ipx max-service-
entries
Specify the maximum number of IPX
services in the service table. Use the
no release of the command to return
to the default value of 2048.
If the maximum number of services is
decreased, the switch must be reboo-
ted for the value to take effect. If the
value is increased, the change occurs
immediately.
<max-service-entries> – the
maximum number of IPX services that
can appear in the service table. The
value must be in the range 1 to 10240.
The value you enter is rounded up to
the nearest multiple of 256.
Command Mode: Configuration
System Supported: P550R
N/A To Enable:
ipx ping-default
{novell|diagnostic}
To Disable:
[no] ipx ping-default
Set the type of IPX ping packet issued
by the router when the ipx ping
command is issued. Use the no form
of the command to return to the
default ping type; novell.
• novell – transmits standard
Novell pings.
• diagnostic – transmits diagnostic
request/response pings.
Command Mode: Configuration
System Supported: P550R
To Enable:
ipx type-20-
propagation
{both|inbound|outbound
|disabled}
To Disable:
[no] ipx type-20-
propagation
To Enable:
N/A
To Disable:
[no] ipx type-20-
propagation
{both|inbound|outbound|
disabled}
• both – The interface accepts and
forwards type 20 propagation
broadcast packets. This is the
default.
• inbound – The interface only
accepts type 20 broadcast packets.
• outbound – The interface only
forwards type 20 propagation
broadcast packets to other
network segments.
• disabled – The interface does not
accept or forward type 20
propagation broadcast packets.
Table 1-8: IPX Commands (Continued)
Old Command New Command New Definition/Argument