Perle Systems Adaptors - Manual (Page 84)

FAST Serial Adaptors User Guide
Installing host cards and distribution accessories
Page 84
Chapter 2 Installing drivers and host cards
I/O address 3. Using jumpers JP1 and JP2 on the host card, set the high order and low order I/O
address you want in hexidecimal using the one of the settings shown in the next table;
Mechanical
installation You can now install the AT host card in your system. To do this proceed as follows;
4. Turn off the power to your system and disconnect the mains supply.
5. Remove the system cover to expose the inside of the connector panel for host cards.
Address JP2 setting JP1 setting
0100 01XX XX00
0140 XX40
0180 XX80
01c0 XXc0
0200 02XX XX00
0240 XX40
0280 XX80
02c0 XXc0
0300 03XX XX00
0340 XX40
0380 XX80
03c0 XXc0
JP2 JP1
JP1 and JP2 set I/O address,
JP2 sets high order address value
JP1 sets low order address value
Note
The exact location of host card slots varies for different systems, for exact mechanical
details of your system, refer to your system documentation.
Warning
Dangerous voltages exist inside computer systems. Before
installing host cards in your system, turn off the power supply
and disconnect the mains lead.