Troubleshooting – Pioneer ELITE DV-49AV User Manual

Page 55

Advertising
background image

09

55

En

Troubleshooting

Incorrect operation is often mistaken for trouble or malfunction. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Inspect the other components and electrical appliances being used. If
the trouble cannot be rectified after checking the items below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.

Problem

Remedy

The disc won’t play or is
automatically ejected after
loading.

• Make sure the disc is free from dirt and dust and is not damaged
(page 52).
• Make sure the disc is loaded with the label side face-up and
aligned properly in the disc tray guide.
• Incompatible region number: If the region number on a
DVD-Video disc does not match the number on the player, the disc
cannot be used (page 54). In this case the attention sentence
“Incompatible disc region number Can’t play disc” is displayed on
screen.
• Condensation inside the player: Allow time for condensation to
evaporate. Avoid using the player near an air-conditioning unit.
• Disc is loaded upside down: Reload the disc with the label side
face up.

DVD-Audio playback stops.

• The disc may have been illegally copied.

Picture playback stops and
the operation buttons
cannot be used.

• Press

STOP, then start playback again ( PLAY).

• Switch the power off once, unplug from the wall socket, then plug
back in and switch on again using the front panel

STANDBY/ON

button.

New settings made in the
Setup screen menus while a
disc is playing are
ineffective.

• Some settings can be changed while a disc is playing, but are not
effective until the disc is stopped then restarted: Press

STOP,

then start playback again (

PLAY).

Settings are canceled.

• When the power is cut due to power failure or by unplugging the
power cord, settings will be canceled: Press

STANDBY/ON on

the front panel to turn the player off. Wait for

-OFF- to disappear

from the display, then unplug the power cord.

The remote control doesn’t
seem to work.

• The remote control is too far from the player, or the angle with the
remote sensor is too wide: Use the remote within its operating
range (page 19).
• The batteries are exhausted: Put in new ones (page 6).

DV49AV_KU_EN.book 55 ページ 2008年6月23日 月曜日 午前11時51分

Advertising