Planet Technology WGSD-1020 - Manual (Page 11)

- 7 -
3. SWITCH MANAGEMENT
This chapter describes how to manage the Switch. Topics include:
- Overview
- Management methods
- Assigning an IP address to the Switch
- Logging on to the Switch
3.1 Overview
The Switch provides a user-friendly, menu driven console interface. Using this interface, you can per-
form various switch configuration and management activities, including:
- Assigning an IP address
- Configuring Switch settings
- Display console port information
- Configuring each port status
- Configuring Port Trunking
- Setting up packet filters
- Setting up VLAN policy
- Configuring STP and port sniffer
- Configuring SNMP parameters
- TFTP Upgrading software
- Backup Switch configuration
Please refer to the following or Chapter 4 and 5 for the details.
3.2 Management Methods
There are three ways to manage the Switch:
- Local Console Management via the Switch serial port.
- Remote Console Management via a network or dial-up connection.
- Web Management via a network or dial-up connection.
- Using an SNMP Network Management Station.
3.2.1 Local Console Management
You can manage the Switch locally by connecting a VT100 terminal, or a personal computer or
workstation with terminal emulation software, to the Switch serial port. The terminal or workstation
connects to the Switch serial port using a null modem cable that has the appropriate connectors on
each end.
This management method is ideal when:
- The network is unreliable
- The Network Manager does not have direct network connection
- A Network Manager does not support SNMP
The serial port of the Switch default setting is set to 9600 baud using a character format of 8 data bits,
no parity, and 1 stop bit.
Therefore, configure the terminal or workstation to use these settings before you log on to the Switch.
You can change this default setting, if desired, after you log on.