3 state activity – Planet Technology WGSD-1020 User Manual
Page 65
- 61 -
5.4.5.3 State Activity
Allow setting the LACP State Activity of each port.
Figure 5-18 WGSD-1020 State Activity Web Page screen
Please check the detail description of parameters as below:
Active( enable ): the port automatically sends LACP protocol packets.
Passive ( not enable Active): the port does not automatically sends LACP protocol packets and only
respond when it receives LACP protocol packets from the opposite device.
Note:
* A link having either two active LACP ports or one active port can perform dynamic LACP
trunking. A link has two passive LACP ports will not perform dynamic LACP trunking, because
both ports are waiting for LACP protocol packets from the opposite device.
*If the switch is active LACP
’s actor, when you are select trunking port, the active status will be
created automatically.
You can click
” Help” button; the following screen in
Figure 5-19
appears.
Figure 5-19 WGSD-1020 Trunk Help Web Page screen
Click
“Close” to close this screen.