Planet Technology WGSD-1020 - Manual (Page 88)

- 84 -
6. SWITCH OPERATION
6.1 Address Table
The Giga Switch is implemented with an address table. This address table composed of many entries.
Each entry is used to store the address information of some node in network, including MAC address,
port no, etc. This information comes from the learning process of Ethernet Switch.
6.2 Learning
When one packet comes in from any port. The Giga Switch will record the source address, port no. and
the other related information in address table. This information will be used to decide either forwarding or
filtering for future packets.
6.3 Forwarding & Filtering
When one packet comes from some port of the Ethernet Switching, it will also check the destination
address besides the source address learning. The Ethernet Switching will lookup the address-table for
the destination address. If not found, this packet will be forwarded to all the other ports except the port
which this packet comes in. And these ports will transmit this packet to the network it connected. If found,
and the destination address is located at different port from this packet comes in, the Ethernet Switching
will forward this packet to the port where this destination address is located according to the information
from address table. But, if the destination address is located at the same port with this packet comes in,
then this packet will be filtered. Thereby increasing the network throughput and availability
6.4 Store-and-Forward
Store-and-Forward is one type of packet-forwarding techniques. A Store-and Forward Ethernet
Switching stores the incoming frame in an internal buffer, do the complete error checking before
transmission. Therefore, no error packets occurrence, it is the best choice when a network needs effi-
ciency and stability.
The Ethernet Switch scans the destination address from the packet-header, searches the routing table
provided for the incoming port and forwards the packet, only if required. The fast forwarding makes the
switch attractive for connecting servers directly to the network, thereby increasing throughput and
availability. However, the switch is most commonly used to segment existing hubs, which nearly always
improves overall performance. A Ethernet Switching can be easily configured in any Ethernet network
environment to significantly boost bandwidth using conventional cabling and adapters.
Due to the learning function of the Ethernet switching, the source address and corresponding port
number of each incoming and outgoing packet are stored in a routing table. This information is subse-
quently used to filter packets whose destination address is on the same segment as the source address.
This confines network traffic to its respective domain, reducing the overall load on the network.
The Giga Switch performs "Store and forward" therefore, no error packets occur. More reliably, it re-
duces the re-transmission rate. No packet loss will occur.
6.5 Auto-Negotiation
The STP ports on the WGSD-1020 switch have built-in "Auto-negotiation". This technology automatically
sets the best possible bandwidth when a connection is established with another network device (usually
at Power On or Reset). This is done by detecting the modes and speeds at the second of both device is
connected and capable of, Both 10Base-T and 100Base-TX devices can connect with the port in either
Half- or Full-duplex mode. 1000Base-T can only be connected in Full-duplex mode.