Panasonic WJ-RT208 - Manual (Page 38)

38
2. While "NetBackup" (data backup function) is being per-
formed using the provided software, VMD response
may be delayed.
Record length (RECORD LENGTH)
(1) Press the [MENU] button. "WJ-RT208 SETUP MENU"
appears. Move the cursor to "REC & EVENT SETUP"
and press the [SET] button. (Refer to steps (1) and (2)
in 3.1.3.)
(2) Move the cursor to "RECORD LENGTH" and press the
[SET] button.
Setup enabled range: 005 - 240
Default: 15
Note: If the "RECORD LENGTH" setup conditions are
changed in the middle of recording, setting becomes
effective at that time point.
(3) Move the cursor to [OK] and press the [SET] button.
Audio selection (AUDIO SELECT)
(1) Press the [MENU] button. "WJ-RT208 SETUP MENU"
appears. Move the cursor to "REC & EVENT SETUP"
and press the [SET] button. (Refer to steps (1) and (2)
in 3.1.3.)
REC & EVENT
TIMER REC
TERMINAL REC
VMD REC
RECORD LENGTH
AUDIO SELECT
OK Cancel
015 Time Per File Min
RECORD LENGTH
Frame rate: "Full, 1/2F, 1/4F, 1/8F, 1/16F"
Default: "Full"
Stream type: "CBR/VBR"
Default: "CBR" (If screen changes seem extreme,
the setting made at "VBR" is preferable.)
Period: "Period1/Period2"
Default: 00:00 - 24:00
(The setup time for "Period1" (or "Period2") is dis-
played when the VMD recording function is started.)
Cautions:
1. When setting is completed, set "Period1" and/or
"Period2" to "On".
2. For [All] operation and functions, refer to the timer
recording explanation.
(3) When setting is completed, move the cursor to [Ok] and
press the [SET] button.
VMD Area Setup (AREA SETUP)
(1) Move the cursor to [OK] and press the [SET] button in
the "VMD REC" menu. A motion detector area setup
screen is displayed.
(2) Areas in green and without color are displayed on the
screen. In the green area, the motion detector has
already been set up, while no setting has been made in
the colorless area. Move the cursor to a setting place
with the direction button and press the [SET] button.
The grid color is turned from green to colorless or from
colorless to green, and the setup change of that grid is
displayed.
(3) Press the [ESC] button to save the setup conditions of
the motion detector area. Move the cursor to [OK] and
press the [SET] button and make settings for parame-
ters other than those of "VMD REC".
Notes:
1. When trying to stop the recording by changing the set-
tings in the process of the VMD recording, recording will
not stop immediately. The VMD recording will not stop
unless time set for "Rec. Interval" has been passed. To
stop the VMD recording, stop recording manually after
changing the settings for the VMD recording.
Cursor
The green areas
are where the
motion detection
has already been
set.
The colorless areas
are where the motion
detection is not set.
REC & EVENT
TIMER REC
TERMINAL REC
VMD REC
RECORD LENGTH
AUDIO SELECT