Planet Technology WGS3-2840 - Manual (Page 13)

- 13 -
access-list Config acl.
arp Set a static ARP entry.
clear clear something.
commit Commit all the ACL and QoS Config to be valid.
debug Debugging functions (see also 'undebug').
enable Modify enable password parameters.
exit End current mode and down to previous mode.
help Description of the interactive help system.
hostname Set system's network name.
interface Select an interface to configure.
ip Global IP configuration subcommands.
key Authentication key management.
line Configure a terminal line.
mac-address-table Configure the MAC address table.
maximum-paths Set multipath numbers installed to FIB.
mls Global Multi-Layer Switching parameters.
monitor Configure SPAN monitoring.
move Move a access-list entry.
no Negate a command or set its defaults.
password Assign the terminal connection password.
policy-map Policy map command.
router Enable a routing process.
router-id Router identifier for this syste.
snmp-server Modify SNMP engine parameters.
spanning-tree config the spanning tree.
vlan 802.1q VLAN status.