Pelco DX2000 - Manual (Page 25)

Pelco Manual C690M-E (11/04) 25
POS Terminals
• Direct Connection
Connect a DX2000DA9 Data Adapter to the serial communications port of the POS
terminal. Attach the RJ-45 cable (supplied with each adapter) from the adapter to any of
the DX2000 data ports.
• PIM Connection
Connect the PIM to the POS terminal. Attach the RJ-11 cable (supplied with each PIM)
from the PIM to any of the DX2000 data ports.
• PV130 RS-422 Converter Connection
Connect the PV130 to the POS terminal. Attach an RJ-45 cable (not supplied) from the
PV130 to data port 3 or 4 on the DX2000.
• DX2000DH Data Hub Connection
Connect the POS terminals to the data hub using the DX2000DA9T Data Adapters and
RJ-45 cables (supplied). Attach a straight RJ-45 cable (25 feet supplied) from the data hub
output port to data port 3 or 4 on the DX2000. An additional DX2000DH is required to
archive 16 alarm inputs.
ATMs
• Direct Connection
Connect a DX2000DA9T Data Adapter to the serial communications port of the ATM.
Attach the RJ-45 cable (supplied with each adapter) from the adapter to any of the
DX2000 data ports.
• Network Connection
Connect a DX2000DA25T Data Adapter to the ATM network (SNA). Attach the RJ-45
cable (supplied with each adapter) from the adapter to data port 1 or 2 on the DX2000.
• DX2000DH Data Hub Connection
Connect the ATM network (SNA or IBM3275) or serial communication port to the data hub
using the DX2000DA9 or DX2000DA25T Data Adapters and RJ-45 cables (supplied).
Attach a straight RJ-45 cable (not supplied) from the data hub output port to data port 3 or
4 on the DX2000. An additional DX2000DH is required to archive 16 alarm inputs.