Pelco DX2000 - Manual (Page 52)

52 Pelco Manual C690M-E (11/04)
Do the following:
1. Click the Configuration button. Click Data Interface. The Data Interface screen appears
with the Data Port Configuration tab displayed.
2. Click the Communication Type Setup tab. The Communication Type Setup screen
appears.
3. Use the pull-down menu in the Communication Type box to view the parameters of the
selected communication type.
4. To add, edit, or delete a communication type selection, do the following. (Remember, the
first three entries in the Communication Type list are predefined and cannot be edited or
deleted.)
a. Click the Add button to define a new communication type. You can now edit the new
communication type’s parameters. The program displays Done and Cancel buttons.
Click Done to accept the new communication type or Cancel to abandon any
changes.
b. Click the Edit button to edit the selected communication type. The program displays
Change and Cancel buttons. Click Change to accept changes to the communication
type or Cancel to abandon any changes.
c. Click the Delete button to delete the selected communication type. (Any communica-
tion type appearing in the Data Port Configuration screen is considered to be in use
and cannot be deleted. Therefore, you must first deselect this communication type for
all devices on that screen; and then you can delete this communication type.)
5. Use the pull-down menu in the Device Type row to select one of the following
Selection Meaning
Standard Printer Standard serial text
Pelco PIM PIM formatted serial text
ATM ATM formatted serial text
6. Use the pull-down menu in the Data Format row to select either ASCII or EBCDIC
character format.