Pioneer VSX-519V-K - Manual (Page 18)

Connecting up 03
18
En
Connecting the speakers
A complete setup of six speakers (including the
subwoofer) is shown below, but everyone’s
home setup will vary. Simply connect the
speakers you have in the manner shown below.
The receiver will work with just two stereo
speakers (the front speakers in the diagram)
but using at least three speakers is
recommended, and a complete setup is best for
surround sound. If you’re not using a
subwoofer, change the front speaker setting
(see Speaker setting on page 35) to LARGE.
Make sure you connect the speaker on the
right to the right terminal and the speaker on
the left to the left terminal. Also make sure the
positive and negative (+/–) terminals on the
receiver match those on the speakers.
Be sure to complete all connections before
connecting this unit to the AC power source.
Bare wire connections
Front speaker terminals:
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
Center and surround speaker terminals:
1 Twist exposed wire strands together.
2 Push open the tabs and insert exposed
wire.
3 Release the tabs.
1 2 3
10 mm
(3/8 in.)
1 2
10 mm
(3/8 in.)
3
AUDIO
ANTENNA
FM
L
R
Class 2 Wiring SPEAKERS A
OUT
Y P B P R
FRONT
ZONE2 OUT
MONITOR OUT BD/DVD IN TV/SAT IN
R L
SURROUND CENTER
SUBWOOFER
PRE OUT
L R
T
OUT IN DVR/VCR VIDEO
L
R
IN
IN
R L
SPEAKERS A
SURROUND CENTER
R L
FRONT
R L SUBWOOFER
PRE OUT
VSX_519V_KU.book Page 18 Wednesday, December 24, 2008 4:38 PM