Pioneer VSX-519V-K - Manual (Page 37)

The System Setup menu 06
37
En
Engli
sh
Françai
s
E
spañol
Speaker Distance
For good sound depth and separation from
your system, you need to specify the distance
of your speakers from the listening position.
The receiver can then add the proper delay
needed for effective surround sound.
1 Select ‘SP DISTN.’ from the SP SETUP menu.
2 Use
/ to choose the speaker that you
want then set the distance.
Use
/ to adjust the distance of each
speaker (in 0.1 ft. (3 cm) increments).
The Input Assign menu
You only need to make settings in the Input
Assign menu if you didn’t hook up your
equipment according to the default settings for
the component video inputs.
• Default settings:
COMP 1 – BD
COMP 2 – TV
If you didn’t make component video
connections according to the defaults above,
you must assign the numbered input to the
component you’ve connected (or else you may
see the video signal of a different component).
For more on this, see Using the component
video jacks on page 16.
1 Select ‘IN ASSIG’ from the System Setup
menu.
2 Select ‘COMP. IN’ from the ‘IN ASSIG’
menu.
3 Use / to select the number of the
component video input to which you’ve
connected your video component.
The numbers match the numbers beside the
inputs on the rear of the receiver.
4 Select the component that corresponds
with the one you connected to that input.
• Use the / buttons and ENTER to
select BD, TV, DVR, MCI (MULTI CH IN)
or OFF.
• If you assign a component input to a
certain function, any component inputs
previously assigned to that function will
automatically be switched off.
• Make sure you have connected the audio
from the component to the corresponding
inputs on the rear of the receiver.
• If you connect any source component to
the receiver using a component video
input, you should also have your TV
connected to this receiver’s
COMPONENT VIDEO OUT
jacks.
VSX_519V_KU.book Page 37 Wednesday, December 24, 2008 4:38 PM