Panasonic WJ-ND200 - Manual (Page 33)

33
About the Event Function
The event action will be performed when the following events occur.
Terminal alarm: When a signal is supplied from an external device such as a door sensor to the ALARM ter-
minal, this is stated as an event of a terminal alarm.
Command alarm: A command alarm is sent from a PC via a network.
Site alarm: An alarm using Panasonic Alarm Protocol is sent from a network camera.
Action at an Event Occurrence
The event action will be performed according to the settings when an event occurs.
Note:
When an event occurred and the corresponding camera’s compression method is "MPEG-4", event recording
may start from a point several seconds after the event occurrence and the recording duration may be shortened
for several seconds.
Starts recording
Recording will be performed according to the settings such as recording duration, recording rate, etc. that were con-
figured on the setup menu. (Refer to the setup instructions (PDF) for further information.)
Depending on the settings, it is possible to start recording images before an event occurs (Pre-event recording).
Displays alarm message
The pop-up window that notifies of an event occurrence will be displayed at an event occurrence.
Blinks the alarm indicator
The alarm indicator on the front panel of the unit will start blinking at an event occurrence.
Sounds the buzzer
The buzzer will start sounding for the set duration according to the settings configured on the setup menu. (Refer to
the setup instructions (PDF) for further information.)
Moves a camera to the preset position
The camera will move to the preset position registered in advance at an event occurrence.
Refer to the operating instructions of the connected camera for the descriptions of how to register the preset posi-
tion.
Notifies of an event occurrence by sending e-mails
When an event occurs, this unit notifies of the event occurrence with the time and date of the event occurrence by
sending e-mails (alarm mails) to the registered addresses. It is also possible to attach an image to the alarm mail.
When an alarm occurred and the corresponding camera’s compression method is "MPEG-4", no image will be
attached to the alarm mail. (It is impossible to attach an MPEG-4 image to the alarm mail.)
Up to 4 addresses can be registered as recipients of the alarm mail.
To send the alarm mail at an event occurrence, it is required to perform the settings on the setup menu in advance.
(Refer to the setup instructions (PDF) for further information.)