Panasonic WJ-ND200 - Manual (Page 58)

58
About the Error Log
The following are the descriptions about the contents of the error log and the network error log.
Content
Power outage detection
Error Log Network log Output from the connector
on the rear panel
PWR LOSS – Outage processing end out-
put
Recover from a power
outage PWR RECOVER – –
Fan warning FAN f – Error output
Thermal error warning
Alteration detection
USE button pressed number
of times
THERMAL
ALTERD **CH
HDD d ON/OFF **
–
–
–
Error output
Error output
HDD error output
HDD Write error W-ERR d – –
HDD Read error R-ERR d – –
HDD S.M.A.R.T. warning SMART d – HDD error output
HDD hour meter warning H.METER d – HDD error output
HDD SKIP warning* 1 SKIP HDD d – –
Remove auto links* 2 REMOVE d – HDD error output
Mirroring recovery failure
Single mode format failure
Mirroring mode format failure
HDD exchange warning
M-FAIL d
HDD d FORMAT-ERR
M-FORMAT-ERR
HDD d EXCHANGE **%
–
–
–
–
HDD error output
HDD error output
HDD error output
Available disk space warn-
ing output
Available capacity warning
Available capacity warning
(FULL)
Network link error
HDD-**%
HDD-FULL
–
–
–
LINK_ERR
Available disk space warn-
ing output
Available disk space warn-
ing output
Network error output
Network camera error
detection CAM cc ERR – Camera error output
Network camera error
recovery CAM cc RECOVER – –
E-mail transmission
complete – SMTPMAIL_SEND –
E-mail authentication error – SMTPATTEST_ERR Network error output
Failed to resolve POP3
server address from DNS – SMTPPOP3ADD_ERR Network error output
Failed to find POP3 server
Failed to resolve SMTP
server address from DNS
–
–
SMTPPOP3SVR_ERR
SMTPSVRADD_ERR
Network error output
Network error output
Failed to find SMTP server – SMTPSVR_ERR Network error output
*1: "HDD SKIP" is the function that continues recording even when an error occurs, such as HDD write error, by
recording images on the next HDD.
*2: "Remove auto links" means unmounting of the hard disk drive without removing the disk from the unit.
MAIL FROM command error – SMTPMAILFROM_ERR Network error output
RCPT TO command error – SMTPRCPTTO_ERR Network error output