Ac outlet operating other pioneer components, Connecting up 03, Ac outlet – Pioneer VSX-2014i User Manual
Page 22: Operating other pioneer components
Connecting up
03
22
En
3-D view of
7.1 channel
speaker setup
AC outlet
Power supplied through this outlet is turned on and off by
the receiver's power switch. Total electrical power
consumption of connected equipment should not exceed
100 W.
Caution
•
Do not connect a TV set
, monitor, heater, or similar
appliance to this unit's AC outlet.
• Do not connect appliances with high power
consumption to the AC outlet in order to avoid
overheating and fire risk. This can also cause the
receiver to malfunction.
• Since a subwoofer or power amplifier can exceed the
100W maximum when playing sources at a high
volume, this type of equipment should not be
connected to the AC outlet.
Note
• This unit should be disconnected by removing the
power plug from the wall socket when not in regular
use (ex. when on vacation).
Power cord caution
• Handle the power cord by the plug. Do not pull out
the plug by tugging the cord and never touch the
power cord when your hands are wet as this could
cause a short circuit or an electric shock. Do not
place the unit, a piece of furniture, etc., on the power
cord, or pinch the cord. Never make a knot in the cord
or tie it with other cords. The power cords should be
routed such that they are not likely to be stepped on.
A damaged power cord can cause a fire or give you
an electrical shock. Check the power cord once in a
while. When you find it damaged, ask your nearest
Pioneer authorized independent service company for
a replacement.
VSX-2014i only
• Make sure you have completely inserted the AC
power cord into the
AC IN
inlet on the rear panel.
• Do not use any power cord other than the one
supplied with this unit.
Operating other Pioneer components
Many Pioneer components have SR
CONTROL
jacks
which can be used to link components together so that
you can use just the remote sensor of one component.
When you use a remote control, the control signal is
passed along the chain to the appropriate component.
Note that if you use this feature,
make sure that you also
have at least one set of analog audio or video jacks
connected
to another component for grounding
purposes.
Note
• If you want to control all your components using this
receiver’s remote control, refer to
Controlling the rest
of your system
on page 53.
• If you have connected a remote control to the
CONTROL IN
jack (using a mini-plug cable), you
won't be able to control this unit using the remote
sensor.
B
L
R
L
(Single)
SURROUND BACK /
SELECTABLE
SELECTABLE
SWITCHED 100W MAX
AC OUTLET
CONTROL
OUT
IN
OUT
IN
CONTROL
Receiver
Remote
control
unit
Other Pioneer products
with CONTROL terminals
Connect to CONTROL
terminal of other
Pioneer products
VSX_2014TX.book.fm Page 22 Wednesday, June 2, 2004 5:21 PM