Pioneer VSX-21 - Manual (Page 21)

SET UP
21
<ARB7181>
1
Press .
2
Press VOL + or – to adjust the volume to an appropriate
level.
3
Press TEST TONE to output the test tone.
The test tone is output in the following order.
• Test tone is only output in Dolby/DTS mode.
4
Adjust speaker levels so that you hear the test tone at
the same volume from each speaker when seated in the
main listening position.
The channel level ranges ± 10 dB.
• Levels can be set for each surround mode.
5
Press TEST TONE to turn off the test tone.
• Sound from the SUB WOOFER seems quiet.
• The speaker volume can be adjusted without outputting the test tone by pressing CHANNEL LEVEL or
CHANNEL SELECT .
• Initial setting is 0 dB.
Optical digital input 3 setting
Sets the input component to be assigned to the optical input 3 jack.
• Initial setting is “TV”.
• You cannot assign the same component to more than one digital input jack. The jack most
recently selected is established for the component and the jack formerly selected is turned off.
• DVD/LD, TV/SAT, CD, MD/TAPE, VCR 1 digital input connection is possible.
Press
% or fi to set the optical digital input 3 (DVD, TV, CD,
MD, VCR 1).
FL CT FR
SR SL SW
memo
dB
SP SIGNAL
SELECT
ANALOG
A
memo
Setting the volume level of each channel (Adjusting the speaker volume balance)
Preparations
DVD/LD
VCR 1
TV/SAT CD
TUNER
VCR 2 MD/TAPE
TV CONTROL
RECEIVER
DSP MODE
CH.SELECT ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2 3
5
0
6
9 +10
TV/VCR CLASS
7 8
4 1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
RECEIVER TV
MUTING
CN.LEVEL EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
1
2
3,5
4
memo
memo