Pioneer VSX-21 - Manual (Page 42)

42
<ARB7181>
Recording from Audio Components
The following operations show you how to record audio to the cassette, DAT, or MD deck connected to the MD/TAPE 1
or TAPE 2 MONITOR jacks.
1
Select the component you want to record.
Press SIG. SELECT on the remote or SIGNAL SELECT on the front
panel to select “ANALOG” when making analog recordings, or
“DIGITAL” when making digital recordings. (Refer to “Switching
ANALOG/DIGITAL signal input” on page 29.)
2
Prepare the program source.
(Tune in the radio station or load the CD, etc.)
3
Insert a blank tape into the cassette deck (MD/TAPE 1 or
TAPE 2 MONITOR) and adjust the recording level (if necessary).
4
Start recording on the cassette deck, then start playback
from the source component.
Other Operations
1 TAPE 2
MONITOR
SIGNAL SELECT
Record monitor (TAPE 2 MONITOR)
If you connect a cassette deck (etc.) with a record monitor function to the
TAPE 2 MONITOR jacks, you can listen to the sound of the recording as it is
being recorded.
Press TAPE 2 MONITOR to switch between the sound of the
recording (TAPE 2 indicator on) and the sound of the source
component (TAPE 2 indicator off).
1
DVD/LD
VCR 1
TV/SAT CD
TUNER
VCR 2 MD/TAPE
TV CONTROL
RECEIVER
DSP MODE
CH.SELECT ATT SIG.SELECT
MIDNIGHT
TEST TONE
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2 3
5
0
6
9 +10
TV/VCR CLASS
7 8
4 1
CHANNEL
MULTI CONTROL
ENTER
VOL VOL
FQ
FQ
+
–
TV FUNC
RECEIVER TV
MUTING
CN.LEVEL EFFECT
FL DIMMER FUNCTION DIRECT
MODE CHECK
COMMANDER
SET UP
Î
MEMU
SIG. SELECT
The receiver’s volume, balance, tone (BASS, TREBLE, and LOUDNESS), and surround effects have no effect
on the recorded signal. memo
• This receiver outputs the input signal directly to the recording
device. As there is no conversion of the audio signal,
recordings cannot be made from analog to digital, and similarly
from digital to analog.
• Recordings cannot be made from TAPE 2 MONITOR to
MD/TAPE 1.
memo